English
资源说明：CPCFPGA is an FPGA-based Amstrad CPC emulator
PLEASE NOTE THAT THIS IS ONLY A PARTIAL REPOSITORY DUMP WHILE I TRY TO SEPARATE PUBLIC AND PRIVATE PARTS... ------------------------------------------------------------------------------- Contents -------- This is the CPC FPGA project - a modern reimplementation of the Amstrad CPC on an FPGA. Whilst it's designed for use with the Amstrad CPC, the board could be used for almost any 8-bit system. Alternatively, it could be used as a cheap FPGA development board that includes a SCART socket, RAM, flash ROM, PS/2 keyboard, twin joystick ports, tape input, etc... The project is structured in these subdirectories: bitstreams Contains FPGA images that can be loaded from SD card client Contains Linux utilities to communicate with the board datasheets Miscellaneous datasheets (obtained publically, but are NOT part of this project) docs Various snippets of documentation I've written at various times hardware/case The case for revision 2 of CPC FPGA, for laser cutter use hardware/eagle The eagle schematic and circuit design for: homeboard30 (revision 1) homeboard99r (revision 2) hardware/spice Various spice analysis snippets library/hdl VHDL files that can be used in projects hosted on CPC FPGA projects Contains FPGA projects to be run on the CPC FPGA. sidecar2 The firmware for the CPC FPGA suport chip stuff Old bits and bobs, to be deleted Makefile Used to build the system README.txt This file ------------------------------------------------------------------------------- Building the CPC FPGA project ----------------------------- The user part of CPC FPGA program can be built simply by running "make". Other build targets: all Rebuild client and bitstreams clean Clean all build files, excluding final targets bitstreams Rebuild all the FPGA bitstream files scan Check to see if the CPC FPGA board is present log Keep an eye on the diagnostic log from the CPC FPGA board dump Dump the CPC FPGA image stored in the PROM reload Reload the CPC FPGA image stored in the PROM xxx.load Reload the CPC FPGA image for project xxx xxx.program Programs the CPC FPGA's PROM with the image for project xxx sidecar2 Rebuild just the firmware dfu Install the firmware reset Resets the firmware ------------------------------------------------------------------------------- LICENCES The Atmega source code uses the LUFA library, licensed under the MIT library. Please see licence/LUFA-License.txt for copyright information. The schematic and board layout are currently licensed under the Creative Commons Attribution-Share Alike 3.0. Please see http://creativecommons.org/licenses/by-sa/3.0/ for more information. If you make derivative works, you must license under a compatible licence and include the following text: Portions of this project are derived from CPC FPGA, (c) 2011-2013 Ranulf Doswell Other than including the above attribution, you should rename the derivative work so that it cannot be confused with the original CPC FPGA project, nor can you refer to CPC FPGA in a manner that suggests the derivative work is endorsed by CPC FGPA or used by CPC FPGA. Any VHDL code is currently not open sourced unless explicitly mentioned. The scope of the project is solely the hardware design and software for the support chip. If you need a commercial licence for the hardware portion of this project, please contact licensing@ranulf.net for more information.
本源码包内暂不包含可直接显示的源代码文件，请下载源码包。
