universal-y-axis-plate-parts
文件大小: unknow
源码售价: 5 个金币 积分规则     积分充值
资源说明:An aluminum y-axis plate for RepRap printers, with matching open-source 3D-printed parts to mount it.
##Universal Y-Axis Plate
The Universal Y-Axis Plate is an aluminum y-axis plate for RepRap printers, with matching open-source 3D-printed parts to mount it.

The universal plate is designed to eliminate the y-axis plate, and combines both y-axis and heatbed plate holes in one design.  The plate is designed and fulfilled by Terawatt Industries.

This repository contains the matching printed (plastic) parts for the universal plate.  All design files are SCAD with some basic paramterization for height.  There are mounts for LM8UU bearings and tensioners with extra height to keep the belt aligned.

##Bill of Materials
Terawatt fulfills this BOM with 18-8 stainless hardware, but any steel alloy is OK.

1. 1x Universal Y-Axis Plate
2. 8x M3 x 40-45mm socket cap screws
3. 4x M3 x 20-25mm socket cap screws
4. 12x M3 nuts
5. 8x M3 Fender Washer
6. 4x printed LM8UU mount spacers (PLA recommended w/high infill ratio)
7. 4x printed LM8UU mounts (PLA recommended w/high infill ratio)
8. 4x LM8UU bearings

##Assembly Instructions
1. Print up the parts required in PLA, or obtain them.
2. Attach a spacer to the plate with 2x M3x45mm screws.  It may be a tight fit that requires a hex wrench to thread completely.  Then attach the LM8UU mounts on top.
3. Place nuts in the traps and tighten each screw evenly.
4. Repeat steps 2-3 for the other 3 mounts.
5. Push LM8UU bearings into the mounts from the sides.  A bearing press makes the job easier.
6. Place an M3x20mm screw in the mount and a nut in the opposite trap.
7. Tighten the screw.  Be careful not to overtension!  The mount will break if overtensioned - when you hear the plastic stress it's time to stop!
8. Repeat steps 6-7 for each mount.

本源码包内暂不包含可直接显示的源代码文件,请下载源码包。