-
-
-
-
-
avr-vfd-iv18
... for the russian IV-18 Vacum Fluorescent Tube.
This is a hardware and software project to control russian IV-18 VFD tubes.
It was initially done using eLua (http://www.eluaproject.net), thus making
the code generic to all supported platforms. The ...
-
vfd-fv651g
A controller for for the Futaba FV651G VFD
A controller for the Vacuum Fluorecent Display Futaba FV651G, available at Pollin (www.pollin.de), using an ATTINY2313 µC and 4094 shift registers. It implements a vUSB interface to be controlled by PC ...
-
VFD-Hardware
My attempt at reverse engineering an old VFD I found.
This is my attempt at partially reverse enginneering an old 40 char VFD I found.
It has five cables, runs on 5V and generates any HV on-board. It contains a
Z80CPUB1 by SGS (ST). Not yet in the ...
-
VFD-Modular-Clock
... is powered by an ATMega328p microcontroller and contains a high-voltage VFD driver that is used to light up the display shield that sits on the top board.
Firmware
--------
The VFD Modular Clock is based on the ATMega328P microcontroller. The ...
-
Adafruit-Graphic-VFD-Display-Library
Adafruit's 128x64 Graphic VFD Display Library
This is a library for our Monochrome 128x64 Graphical VFD
Pick one up today in the adafruit shop!
------> http://www.adafruit.com/products/773
These displays use SPI to communicate, 5 pins are required ...
-
VFD
ATMega328 based controller for VFD
Controller for VFD (2x20) based on ATMega328
Firmware dependencies(from memory): avr-gcc avrdude
-
VFD
VFD routines for Futaba displays via Serial interfaces
routines for FUTABA VFD displays for ARDUINO.
Currently supported VFD's:
+ M162SD13AA (16x2 characters display, synchronous Serial Interface)
supports graymode
+ M12BY02AA_B (12 character alpha ...
-
Go To English Version 超过100万源码资源，1000万源码文件免费下载
