-
-
satar
... server providing an
API and web user interface.
Node hardware: Atmel AtMega 328/1280 or higher,
Microchip ENC28J60 or Wiznet W5100 via ... hardware SPI enabled with eth0 SPI CSN at port 10.
AtMega clocked at 16Mhz, Microchip clocked at 25Mhz.
- RC1.5: ...
-
arduino_sketches
... [ ]
Boot into bootloader.................... [X]
Divide clock by 8....................... [ ]
Clock output............................ [ ]
```
Atmega\_Self\_Read_Signature
--------------------------
See forum post: http://www.gammon.com.au/forum/?id= ...
-
simpleclock
... =0xe2
simpleclock.bootloader.high_fuses=0xD8
simpleclock.bootloader.extended_fuses=0x05
simpleclock.bootloader.path=atmega
simpleclock.bootloader.file=ATmegaBOOT_168_atmega328_pro_8MHz.hex
simpleclock.bootloader.unlock_bits=0x3F
simpleclock.bootloader. ...
-
USBasp
... firmware upgrade (not self-upgradable)
Set this jumper for flashing the ATMega(4)8 of USBasp with another working
programmer.
J3 SCK option ...
3. run "make main.hex"
4. flash "main.hex" to the ATMega(4)8. E.g. with uisp or avrdude (check
the Makefile ...
-
lpd8806
Firmware for ATmega(x)8-based LPD8806 RGB LED strip controller board.
-
Messenger
A simple one wire Atmega to Atmega communication Arduino library. It uses SoftwareSerial so that it's capable of multiple connections.
-
utilities
... the latest stable Arduino hex code.
- Calling setgpio to enable the pin on the Beagle that is attached to the ATMEGA reset pin on the Arduino.
- Calling setserial to enable the UART serial port for programming the Arduino.
- Calling avrdude and ...
-
progressMeter
... sketch reads the byte from the serial port and maps it as a value, 0-254
using the Pulse Width Modulation feature of the Atmega to control an
attached voltmeter. The nominal output in a simple Arduino setup with a
meter will be within the range 0-5 volts ...
-
ArduinoClone
... to a PCB manufacturer to order a PCB of the arduino clone. This is the first clone and although has the pins to program the ATMega, you must first burn a bootloader which can be a pain. I would recommend using an Arduino to load the code and then swapping ...
-
openrov-electronics
... and control board that has an Arduino based Atmega 2560 aboard. Tons of I/O, and is ... and control board that has an Arduino based Atmega 2560 aboard. Tons of I/O, and is ... Cape A1.
>It is a all-in one power and control board based around the Atmega 328. ...
-
Go To English Version 超过100万源码资源，1000万源码文件免费下载
